ACS-450 – LTE450 CAT 1 M.2 Modem
The Duragon ACS-450 brings LTE450 connectivity to ER- and DR-series routers, which include a M.2 modem socket. This CAT 1 LTE module is capable of supporting all the most commonly used 450MHz LTE bands. The modem does not include SIM interfaces onboard, the SIM and eSIM are to be mounted on the router’s system board. ER- and DR-series routers, which have multiple M.2 modem sockets, the ACS-450 can be used together with a MIMO 2x2 5G modem in the DURION DR01 router. This scenario enables the use of public 5G and LTE450 networks together depending on use cases.
Apart from providing a data and SMS interfaces, the ACS-450 module supports voice calls. The audio output of the modem drives a 3.1W mono amplifier, which can connect to an external power amplifier of small speaker. The MIC input likewise is MONO, with internal active MIC-Bias circuitry. An external audio adapter is available with a 3.5mm audio jack.
Two status LEDs are supported, the modem status LED is located on the modem board, while the Network Status LED signal is present in the M.2 interface.
- Highlights
- APPLICATIONS
- Specifications
- M.2 form factor LTE450 modem
- USB 2.0 Host interface
- Dual SIM support (uSIM and eSIM)
- LTE-FDD B1/B3/B5/B7/B8/B20/B28/B31/B72
- Compliant with 3GPP TS 27.007, 3GPP TS 27.005
- Modem and Network Status indicators
- Support for voice calls
- 3.1W Mono audio amplifier onboard
- Electret MIC input with Bias
- u.FL antenna connector
- Compatible with ER- and DR-series routers
- Operating temperature range -35 °C to +75 °C
- Public safety vehicle routers
- Multi-path tactical EDGE router
- Private LTE450 networks
MODEM:
- LTE-FDD B1/B3/B5/B7/B8/B20/B28/B31/B72
SIM:
- 2x SIM Interfaces
- Software selectable using AT commands
- uSIM (SIM 1) and eSIM (SIM 2) support
Audio:
- MONO microphone input with microphone BIAS
- MONO audio preamplifier for speaker
Connectors:
- u.FL for cellular antenna
- 1734839-5 0.5mm pitch FPC connector for Audio
( 3.5mm jack adapter available)
Management:
- Microcontroller for reset and USB-Boot management
Interface:
- USB 2.0
Mechanical:
- B-code M.2 form factor, 30 x 52 mm size
Power:
- 7W Peak @ 2.5A
Indicators:
- 1x MODEM Status (onboard), 1x Link Status (M.2)
Firmware:
- Supports USB Booting